Re: [16NG] ipv6 over ipv6cs document approval

[Basavaraj Patil <[e-mail]>]

One of the reasons for choosing a PtP link model is to avoid the issues
related to ND.
Because of the PtP link type there is no question about an MS being
transitioned out of Idle mode because of ND.
The document does not need to specify anything further regarding ND.

-Raj


On 11/22/07 3:01 AM, "ext Junghoon Jee" <[e-mail]> wrote:

> Hi Jari,
>  
> I agree to apply the suggested changes.
>  
> Let me share my unsolved question regarding how to deal with neighbor
> discovery packets for IPv6CS case.
>  
> Do we have to block neighbor discovery packets not to wake up idle/sleep SSs ?
> Or,
> Do we have to let them delivered in that p2p link not to break the NUD model?
> Is there no need to specify about that in this document?
>  
> BR,
> Junghoon
> 
>  
> 2007/11/22, Jari Arkko <[e-mail]>:
>> 
>> We're trying to close the remaining issues and approve
>> the current document.
>> 
>> The current proposal is what we have in the draft, with
>> the following changes. If there is any concern with
>> these changes, let me know as soon as possible.
>> 
>> There are a few editorial changes. The substantive
>> changes are clarifying MTU rules in the presence
>> of tunneling on the BS side, and strengthening
>> the requirements related to interoperability.
>> 
>> ----
>> 
>> Please change in Section 8.1:
>> 
>> OLD:
>>    The use of router advertisements as a means for movement detection is
>>    not recommended for MNs connected via 802.16 links as the frequency
>>    of periodic router advertisements can be high.
>> NEW:
>>    The use of router advertisements as a means for movement detection is
>>    not recommended for MNs connected via 802.16 links as the frequency
>>    of periodic router advertisements would have to be high.
>> 
>> Please add new text at the end of Section 4 (just before 4.1),
>> these are the new paragraphs:
>> 
>>    In any case, the MS and BS MUST negotiate at most one
>>    convergence sublayer for IPv6 transport on a given link.
>> 
>>    In addition, to ensure interoperability between devices that
>>    support different encapsulations, it is REQUIRED that BS
>>    implementations support all standards track encapsulations
>>    defined for 802.16 by the IETF. At the time of writing this
>>    specification, this is the only encapsulation, but additional
>>    specifications are being worked on. It is, however, not
>>    required that the BS implementations use all the encapsulations
>>    they support; some modes of operation may be off by
>>    configuration.
>> 
>> Change in Appendix D:
>> 
>> OLD:
>>    It is
>>    recommended that the default MTU for IPv6 be set to 1400 octets for
>>    the MS in WiMAX networks.
>> NEW:
>>    It is recommended that the MTU for IPv6 be set to 1400 octets in
>>    WiMAX networks, and this value (different from the default)
>>    be communicated to the MS.
>> 
>> Change Section 6.3 to:
>> 
>>   The MTU value for IPv6 packets on an 802.16 link is configurable.
>>   The default MTU for IPv6 packets over an 802.16 link SHOULD be 1500
>>   octets.
>> 
>>   The 802.16 MAC PDU (Protocol Data Unit) is composed of a 6 byte
>>   header followed by an optional payload and an optional CRC covering
>>   the header and the payload.  The length of the PDU is indicated by
>>   the Len parameter in the Generic MAC Header.  The Len parameter has a
>>   size of 11 bits.  Hence the total MAC PDU size is 2048 bytes.  The
>>   IPv6 payload size can vary.  In certain deployment scenarios the MTU
>>   value can be greater than the default.  Neighbor Discovery for IPv6
>>   [RFC4861] defines an MTU option that an AR MUST advertise, via router
>>   advertisement (RA) if a value different from 1500 is used.
>>   If an AR advertises an
>>   MTU via the RA MTU option, the MN SHOULD use the MTU from the RA.
>>   Nodes that implement Path MTU discovery [RFC1981] MAY use the
>>   mechanism to determine the MTU for the IPv6 packets.
>> 
>> In the abstract:
>>    s/fxed/fixed/
>> 
>> In section 6.1:
>>    s/it is recommended that a tunnel is established/it is recommended
>>    that a tunnel be established/
>> 
>> 
>> 
>> _______________________________________________
>> 16NG mailing list
>> [e-mail]
>> https://www1.ietf.org/mailman/listinfo/16ng
>> <https://www1.ietf.org/mailman/listinfo/16ng>
>> 
> 
> 
> _______________________________________________
> 16NG mailing list
> [e-mail]
> https://www1.ietf.org/mailman/listinfo/16ng

_______________________________________________
16NG mailing list
[e-mail]
https://www1.ietf.org/mailman/listinfo/16ng