Re: [82attendees] IPv6 on a D-Link AP?

On 11/16/2011 09:27 AM, Morgan Sackett wrote:
> Just a question, but do you have it in a bridged mode, or are you
> running it as a NAT box?
Bridged mode is probably the answer, short term. This would also work 
with APs that don't support IPv6.

I suspect that it'll still be answering on 192.168.1.1 on the public net 
- otherwise it's hard to get to the box for turning DHCP back on later. 
Shouldn't be a real problem.

Would be nice to have DHCPv6 prefix delegation available, but I suspect 
the box doesn't support that. At least not with the image it came with :-)
> -Morgan
>
>
>
> On Wed, Nov 16, 2011 at 9:22 AM, Harald Alvestrand<harald@alvestrand.no>  wrote:
>> Greetings folks,
>> just randomly puttering around:
>> in Quebec City I ended up buying a D-Link DIR-401 WLAN AP, and was tickled
>> to find that it supported IPv6!
>> however....
>>
>> plugging it into the (wired-only) IETF network in my room did not magically
>> get working IPv6 on my wireless. Seemingly, there is no supported way to
>> magically snarf a prefix from the net and announce it on my WLAN segment.
>>
>> Is there a working way to do this?
>>
>> Failing working magic - is there a way to get a subnet assignment that I can
>> configure on the box?
>>
>>                       Harald
>>
>> _______________________________________________
>> 82attendees mailing list
>> 82attendees@ietf.org
>> https://www.ietf.org/mailman/listinfo/82attendees
>>