Re: [codec] draft test and processing plan for the IETF Codec

[Koen Vos <[e-mail]>]

Stephen Botzko wrote: 
> If you simply want to know which "sounds better" to the user, 

That's probably the best you can hope for yes. 

> then perhaps bandpass filtering gets in the way. 

Correct. 

> If you want to see if there are there is an underlying difference in intelligibility 
> or user tolerance for the coding artifacts,, then the bandpass filtering might be 
> useful, since it controls for the known preference that users have for wider 
> frequency response. 

Sounds like an interesting academic study. You should also look into any 
long-term health effects (so you can argue for a 5 year test plan!). 

One thing we know for sure though: pre-distoring test signals creates a bias in the 
results and thus invalidates any conclusion from the test. 

best, 
koen. 


----- Original Message -----
From: "Stephen Botzko" <[e-mail]> 
To: "Koen Vos" <[e-mail]> 
Cc: "Paul Coverdale" <[e-mail]>, [e-mail] 
Sent: Monday, April 18, 2011 4:18:05 AM 
Subject: Re: [codec] draft test and processing plan for the IETF Codec 

in-line 
Stephen Botzko 


On Mon, Apr 18, 2011 at 3:27 AM, Koen Vos < [e-mail] > wrote: 


Hi Paul, 


> I think where this discussion is going is that we need to be more 
> precise in defining what we mean by "NB", "WB", "SWB" and "FB" if 
> we want to make meaningful comparisons between codecs. 

The discussion so far was about whether to pre-distort test signals by 
bandpass filtering. 


I think this might depend on what you want to learn from the test. 

If you simply want to know which "sounds better" to the user, then perhaps bandpass filtering gets in the way. 

If you want to see if there are there is an underlying difference in intelligibility or user tolerance for the coding artifacts,, then the bandpass filtering might be useful, since it controls for the known preference that users have for wider frequency response. 




I don't see what the name of a codec's mode has to do with meaningful 
comparisons. It's the sampling rate that matters: what happens when a 
VoIP application swaps one codec for another while leaving all else the 
same. So where possible you want to compare codecs running at equal 
sampling rates. That gives a clear grouping of codecs for 8, 16 and 
48 kHz (some call these NB, WB and FB). 

The open question is what to do in between 16 and 48 kHz. Opus accepts 
24 kHz signals, other codecs use 32 kHz (and they all call it SWB). 
Here you could either compare directly, which puts the 32 kHz codecs at 
an advantage. Or you could run Opus in FB mode by upsampling the 32 
kHz signal to 48 kHz, as Jean-Marc suggested for 32 and 64 kbps. 


best, 
koen. 


----- Original Message ----- 
From: "Paul Coverdale" < [e-mail] > 
To: "Koen Vos" < [e-mail] > 
Cc: [e-mail] , "Anisse Taleb" < [e-mail] > 



Sent: Sunday, April 17, 2011 5:40:33 PM 
Subject: RE: [codec] draft test and processing plan for the IETF Codec 

Hi Koen, 

There's no doubt that increased audio bandwidth, other things being equal, enhances the perception of quality (well, up to the point where the input signal spectrum itself runs out of steam). I think where this discussion is going is that we need to be more precise in defining what we mean by "NB", "WB", "SWB" and "FB" if we want to make meaningful comparisons between codecs. In fact, the nominal -3 dB passband bandwidth of G.722 is actually a minimum of 50 to 7000 Hz, you can go up to 8000 Hz and still meet the anti-aliassing requirement. 

Regards, 

...Paul 

>-----Original Message----- 
>From: Koen Vos [mailto: [e-mail] ] 
>Sent: Sunday, April 17, 2011 1:44 AM 
>To: Paul Coverdale 
>Cc: [e-mail] ; Anisse Taleb 
>Subject: Re: [codec] draft test and processing plan for the IETF Codec 
> 
>Hi Paul, 
> 
>> The filtering described in the test plan [..] is there to establish 
>> a common bandwidth (and equalization characteristic in some cases) 
>> for the audio chain (be it NB, WB, SWB) so that subjects can focus 
>> on comparing the distortion introduced by each of the codecs in the 
>> test, without confounding it with bandwidth effects. 
> 
>I believe it would be a mistake to test with band-limited signals, for 
>these reasons: 
> 
>1. Band-limited test signals are atypical of real-world usage. People 
>in this WG have always emphasized that we should test with realistic 
>scenarios (like network traces for packet loss), and the proposal goes 
>against that philosophy. 
> 
>2. Band limiting the input hurts a codec's performance. In the Google 
>test for instance, Opus-WB@20 kbps outperformed the LP7 anchor -- 
>surely that wouldn't happen if Opus ran on an LP7 signal. That makes 
>the proposed testing procedure less relevant for deciding whether this 
>codec will be of value on the Internet. 
> 
>3. Audio bandwidth matters to end users. Real-life experiments show 
>that codecs with more bandwidth boost user ratings and call durations. 
>(E.g. see slides 2, 3 of 
> http://www.ietf.org/proceedings/77/slides/codec-3.pdf ) 
>So if a codec scores higher "just" because it encodes more bandwidth, 
>that's still a real benefit to users. And the testing procedure 
>proposed already reduces the impact of differing bandwidths, by using 
>MOS scores without pairwise comparisons. 
> 
>4. Testing with band-limited signals risks perpetuating crippled codec 
>design. In order to do well in the tests, a codec designer would be 
>"wise" to downsample the input or otherwise optimize towards the 
>artificial test signals. This actually lowers the performance for 
>real-world signals, and usually adds complexity. And as long as 
>people design codecs with a band-limited response, they'll argue to 
>test with one as well. Let's break this circle. 
> 
>I also found it interesting how the chosen bandwidths magically match 
>those of ITU standards, while potentially hurting Opus. For instance, 
>Opus-SWB has only 12 kHz bandwidth, but would still be tested with a 
>14 kHz signal. 
> 
>best, 
>koen. 
> 
> 
>----- Original Message ----- 
>From: "Paul Coverdale" < [e-mail] > 
>To: "Koen Vos" < [e-mail] > 
>Cc: [e-mail] , "Anisse Taleb" < [e-mail] > 
>Sent: Saturday, April 16, 2011 6:25:04 PM 
>Subject: RE: [codec] draft test and processing plan for the IETF Codec 
> 
>Hi Koen and Jean-Marc, 
> 
>The filtering described in the test plan is not meant to be for anti- 
>aliassing, it is there to establish a common bandwidth (and equalization 
>characteristic in some cases) for the audio chain (be it NB, WB, SWB) so 
>that subjects can focus on comparing the distortion introduced by each 
>of the codecs in the test, without confounding it with bandwidth 
>effects. 
> 
>Regards, 
> 
>...Paul 
> 
>>-----Original Message----- 
>>From: Koen Vos [mailto: [e-mail] ] 
>>Sent: Saturday, April 16, 2011 4:07 PM 
>>To: Paul Coverdale 
>>Cc: [e-mail] ; Anisse Taleb 
>>Subject: Re: [codec] draft test and processing plan for the IETF Codec 
>> 
>>Paul Coverdale wrote: 
>>> You mean that VoIP applications have no filtering at all, not even 
>>> anti-aliassing? 
>> 
>>The bandpass filter in the test plan runs on the downsampled signal, 
>>so it's not an anti-aliasing filter. 
>> 
>>Also, the plan's bandpass for narrowband goes all the way up to Nyquist 
>>(4000 Hz), whereas for wideband it goes only to 7000 Hz. So if the 
>>bandpass filters were to somehow deal with aliasing, they are not being 
>>used consistently. 
>> 
>>I presume the resamplers in the plan use proper anti-aliasing filters 
>>representative of those in VoIP applications (and described in 
>>Jean-Marc's post). 
>> 
>>best, 
>>koen. 
>> 
>> 
>>----- Original Message ----- 
>>From: "Paul Coverdale" < [e-mail] > 
>>To: "Koen Vos" < [e-mail] >, "Anisse Taleb" 
>>< [e-mail] > 
>>Cc: [e-mail] 
>>Sent: Saturday, April 16, 2011 4:42:06 AM 
>>Subject: RE: [codec] draft test and processing plan for the IETF Codec 
>> 
>>Hi Koen, 
>> 
>>You mean that VoIP applications have no filtering at all, not even 
>>anti-aliassing? 
>> 
>>...Paul 
>> 
>>>-----Original Message----- 
>>>From: [e-mail] [mailto: [e-mail] ] On Behalf 
>>>Of Koen Vos 
>>>Sent: Saturday, April 16, 2011 1:04 AM 
>>>To: Anisse Taleb 
>>>Cc: [e-mail] 
>>>Subject: Re: [codec] draft test and processing plan for the IETF Codec 
>>> 
>>>Hi Anisse, 
>>> 
>>>I noticed your plan tests with band-limited signals: Narrowband 
>signals 
>>>are 
>>>filtered from 300-4000 Hz, Wideband from 50-7000 Hz, Superwideband 
>from 
>>>50-14000 Hz. 
>>> 
>>>However, VoIP applications have no such band-pass filters (which 
>>degrade 
>>>quality and add complexity). So results will be more informative to 
>>the 
>>>WG 
>>>and potential adopters of the codec if the testing avoids band-pass 
>>>filtering as well. We want test conditions to mimic the real world as 
>>>closely as possible. 
>>> 
>>>Instead of band-pass filtering, tests on speech could use a simple 
>>high- 
>>>pass 
>>>filter with a cutoff around 50 Hz, as many VoIP applications do indeed 
>>>have 
>>>such a filter. 
>>> 
>>>best, 
>>>koen. 
>>> 
>>> 
>> 
> 


_______________________________________________ 
codec mailing list 
[e-mail] 
https://www.ietf.org/mailman/listinfo/codec