[ippm] FW: New Version Notification for draft-mdt-ippm-explicit-flow-measurements-01.txt

[Cociglio Mauro <[e-mail]>]

Dear all.

In this new version of Explicit Measurements draft (https://tools.ietf.org/html/draft-mdt-ippm-explicit-flow-measurements-01), the methodology for measuring RTT via the Delay Bit has been updated.
In previous versions the Delay Bit was an additional bit to the Spin Bit that allowed to remedy the weaknesses of the Spin Bit (due to losses, out-of-sequence and application delays). In this new version the Delay Bit works with a new algorithm that makes it completely independent from the Spin Bit and therefore allows it to be used alone, obtaining precise RTT measurements with the use of a single bit.

The draft will be presented at IETF 110, Friday (March 12, 2021), Session III, 16:00-18:00 UTC, Room 9, IPPM WG.
Of course, any comments and questions are more than welcome.
Best regards.

Mauro
_____________________
Mauro Cociglio
Telecom Italia - TIM
Via G. Reiss Romoli, 274
10148 - Torino (Italy)
Tel.: [phone]
Mobile: [phone]
_____________________


TIM - Uso Interno - Tutti i diritti riservati.

-----Messaggio originale-----
Da: [e-mail] <[e-mail]> 
Inviato: lunedì 22 febbraio 2021 19:12
A: Alexandre Ferrieux <[e-mail]>; Dmitri Tikhonov <[e-mail]>; Bulgarella Fabio (Guest) <[e-mail]>; Giuseppe Fioccola <[e-mail]>; Igor Lubashev <[e-mail]>; Isabelle Hamchaoui <[e-mail]>; Nilo Massimo <[e-mail]>; Cociglio Mauro <[e-mail]>; Riccardo Sisto <[e-mail]>
Oggetto: New Version Notification for draft-mdt-ippm-explicit-flow-measurements-01.txt


A new version of I-D, draft-mdt-ippm-explicit-flow-measurements-01.txt
has been successfully submitted by Giuseppe Fioccola and posted to the IETF repository.

Name:		draft-mdt-ippm-explicit-flow-measurements
Revision:	01
Title:		Explicit Flow Measurements Techniques
Document date:	2021-02-22
Group:		Individual Submission
Pages:		39
URL:            https://www.ietf.org/archive/id/draft-mdt-ippm-explicit-flow-measurements-01.txt
Status:         https://datatracker.ietf.org/doc/draft-mdt-ippm-explicit-flow-measurements/
Htmlized:       https://datatracker.ietf.org/doc/html/draft-mdt-ippm-explicit-flow-measurements
Htmlized:       https://tools.ietf.org/html/draft-mdt-ippm-explicit-flow-measurements-01
Diff:           https://www.ietf.org/rfcdiff?url2=draft-mdt-ippm-explicit-flow-measurements-01

Abstract:
   This document describes protocol independent methods called Explicit
   Flow Measurement Techniques that employ few marking bits, inside the
   header of each packet, for loss and delay measurement.  The
   endpoints, marking the traffic, signal these metrics to intermediate
   observers allowing them to measure connection performance, and to
   locate the network segment where impairments happen.  Different
   alternatives are considered within this document.  These signaling
   methods apply to all protocols but they are especially valuable when
   applied to protocols that encrypt transport header and do not allow
   traditional methods for delay and loss detection.

                                                                                  


Please note that it may take a couple of minutes from the time of submission until the htmlized version and diff are available at tools.ietf.org.

The IETF Secretariat

Questo messaggio e i suoi allegati sono indirizzati esclusivamente alle persone indicate. La diffusione, copia o qualsiasi altra azione derivante dalla conoscenza di queste informazioni sono rigorosamente vietate. Qualora abbiate ricevuto questo documento per errore siete cortesemente pregati di darne immediata comunicazione al mittente e di provvedere alla sua distruzione, Grazie. 

This e-mail and any attachments is confidential and may contain privileged information intended for the addressee(s) only. Dissemination, copying, printing or use by anybody else is unauthorised. If you are not the intended recipient, please delete this message and any attachments and advise the sender by return e-mail, Thanks. 

Rispetta l'ambiente. Non stampare questa mail se non è necessario.