[bmwg] RE: IGP Convergence

Thanks Diego and others at Ixia!  I will incorporate these changes into what
is intended to be the final version of these drafts.  I have previously
received comments from a couple of reviewers at Spirent, so leading test
equipment vendors have provided input into this work item.

BMWG-ers,  If there are any further comments then please raise them now.

Thanks,
Scott

-----Original Message-----
From: Diego Dugatkin [mailto:diego@ixiacom.com]
Sent: Friday, April 29, 2005 8:23 PM
To: bmwg@ietf.org; sporetsky@quarrytech.com
Cc: Al Morton; Kevin Dubray
Subject: IGP Convergence

Please find the following feedback on the IGP Convergence drafts:

http://www.ietf.org/internet-drafts/draft-ietf-bmwg-igp-dataplane-conv-meth-
05.txt
<http://www.ietf.org/internet-drafts/draft-ietf-bmwg-igp-dataplane-conv-meth
-05.txt> 

http://www.ietf.org/internet-drafts/draft-ietf-bmwg-igp-dataplane-conv-term-
05.txt
<http://www.ietf.org/internet-drafts/draft-ietf-bmwg-igp-dataplane-conv-term
-05.txt> 

http://www.ietf.org/internet-drafts/draft-ietf-bmwg-igp-dataplane-conv-app-0
5.txt
<http://www.ietf.org/internet-drafts/draft-ietf-bmwg-igp-dataplane-conv-app-
05.txt> 

Overall, we find these drafts solid and have only a few small comments:

1.                Methodology doc, page 6: it was a bit confusing if they
were talking about reporting the timer values of the DUT or the emulated
devices.  One can assume it's the DUT but a word or two could make this
clearer.

2.                Methodology doc, page 6-8: in the test procedure for
4.1.1, steps 4 and 7 mention SONET specifically.  Unless these test cases
are only for SONET they should make this a more generic statement for
removing the layer-1 connection (e.g. disconnect an Ethernet cable).  The
same issue appears in the other test cases.

3.                Methodology doc, page 10:  test case 4.4 is missing step
5.

(I have also sent other comments directly to Scott, discussing precision of
the convergence time measurements based on the proposed methodology, and a
potential modification to that.)

Regards,

Dr. Diego Dugatkin

Principal Technologist

Ixia

26601 West Agoura Road

Calabasas, CA 91302 - U.S.A.

www.ixiacom.com <http://www.ixiacom.com> 

Tel. direct:  +1 (818) 444-3124