I-D Action:draft-ietf-shim6-proto-10.txt

A New Internet-Draft is available from the on-line Internet-Drafts directories.
This draft is a work item of the Site Multihoming by IPv6 Intermediation Working Group of the IETF.

	Title           : Shim6: Level 3 Multihoming Shim Protocol for IPv6
	Author(s)       : E. Nordmark, M. Bagnulo
	Filename        : draft-ietf-shim6-proto-10.txt
	Pages           : 138
	Date            : 2008-02-14

This document defines the Shim6 protocol, a layer 3 shim for
providing locator agility below the transport protocols, so that
multihoming can be provided for IPv6 with failover and load sharing
properties, without assuming that a multihomed site will have a
provider independent IPv6 address prefix which is announced in the
global IPv6 routing table.  The hosts in a site which has multiple
provider allocated IPv6 address prefixes, will use the Shim6 protocol
specified in this document to setup state with peer hosts, so that
the state can later be used to failover to a different locator pair,
should the original one stop working.

A URL for this Internet-Draft is:
http://www.ietf.org/internet-drafts/draft-ietf-shim6-proto-10.txt

To remove yourself from the I-D Announcement list, send a message to
i-d-announce-request@ietf.org with the word unsubscribe in the body of 
the message.
You can also visit https://www1.ietf.org/mailman/listinfo/I-D-announce
to change your subscription settings.

Internet-Drafts are also available by anonymous FTP. Login with the 
username "anonymous" and a password of your e-mail address. After 
logging in, type "cd internet-drafts" and then
	"get draft-ietf-shim6-proto-10.txt".

A list of Internet-Drafts directories can be found in
http://www.ietf.org/shadow.html
or ftp://ftp.ietf.org/ietf/1shadow-sites.txt

Internet-Drafts can also be obtained by e-mail.

Send a message to:
	mailserv@ietf.org.
In the body type:
	"FILE /internet-drafts/draft-ietf-shim6-proto-10.txt".

NOTE:   The mail server at ietf.org can return the document in
	MIME-encoded form by using the "mpack" utility.  To use this
	feature, insert the command "ENCODING mime" before the "FILE"
	command.  To decode the response(s), you will need "munpack" or
	a MIME-compliant mail reader.  Different MIME-compliant mail readers
	exhibit different behavior, especially when dealing with
	"multipart" MIME messages (i.e. documents which have been split
	up into multiple messages), so check your local documentation on
	how to manipulate these messages.

Below is the data which will enable a MIME compliant mail reader
implementation to automatically retrieve the ASCII version of the
Internet-Draft.