Document Action: Printer Finishing MIB to Informational
The IESG <iesg-secretary@ietf.org> Wed, 11 June 2003 20:28 UTC
Received: from asgard.ietf.org (asgard.ietf.org [10.27.6.40]) by ietf.org (8.9.1a/8.9.1a) with ESMTP id QAA19595 for <ietf-announce-web-archive@odin.ietf.org>; Wed, 11 Jun 2003 16:28:30 -0400 (EDT)
Received: from majordomo by asgard.ietf.org with local (Exim 4.14) id 19QBsC-0002Ou-R1 for ietf-announce-list@asgard.ietf.org; Wed, 11 Jun 2003 16:07:08 -0400
Received: from ietf.org ([10.27.2.28]) by asgard.ietf.org with esmtp (Exim 4.14) id 19QBmL-0002Bc-8p for all-ietf@asgard.ietf.org; Wed, 11 Jun 2003 16:01:05 -0400
Received: from CNRI.Reston.VA.US (localhost [127.0.0.1]) by ietf.org (8.9.1a/8.9.1a) with ESMTP id OAA20531; Wed, 11 Jun 2003 14:29:14 -0400 (EDT)
Message-Id: <200306111829.OAA20531@ietf.org>
To: IETF-Announce:;
Cc: RFC Editor <rfc-editor@isi.edu>, Internet Architecture Board <iab@iab.org>
From: The IESG <iesg-secretary@ietf.org>
Subject: Document Action: Printer Finishing MIB to Informational
Date: Wed, 11 Jun 2003 14:29:14 -0400
Sender: owner-ietf-announce@ietf.org
Precedence: bulk
The IESG has approved the Internet-Draft 'Printer Finishing MIB' <draft-ietf-printmib-finishing-16.txt> as an Informational RFC. This has been reviewed in the IETF but is not the product of an IETF Working Group. The IESG contact persons are Ned Freed and Ted Hardie. Technical Summary This document defines a MIB module for the management of printer finishing device subunits. The finishing device subunits applicable to this MIB are an integral part of the Printer System. This MIB does not apply to a Finisher Device that is not connected to a Printer System. Working Group Summary This document was reviewed by the Internet Print Protocol Working Group but is not a product of that group. Protocol Quality Bert Wijnen and Ned Freed reviewed the document for the IESG. RFC Editor Note In the Abstract, please change: "This MIB does not apply to a Finisher Device that is not connected to a Printer System." to: "This MIB applies only to a Finisher Device that is connected to a Printer System." Thanks. Ned