Re: [nvo3] FW: New Version Notification for draft-spallagatti-bfd-vxlan-03.txt

Thanks Greg.

Perhaps what you meant to say was that the Ethertype in the inner MAC
header must be either IPv4 or IPv6.

Anoop

On Mon, May 23, 2016 at 2:46 PM, Gregory Mirsky <gregory.mirsky@ericsson.com
> wrote:

> Hi Anoop, Larry, Shahram, et. al,
>
> thank you for the correction. We’ll address it in the next update.
>
>
>
>                 Regards,
>
>                                 Greg
>
>
>
> *From:* Rtg-bfd [mailto:rtg-bfd-bounces@ietf.org] *On Behalf Of *Anoop
> Ghanwani
>
> *Sent:* Monday, May 23, 2016 2:35 PM
> *To:* Greg Mirsky
> *Cc:* rtgwg-ooam-dt@ietf.org; rtg-bfd@ietf.org; nvo3@ietf.org
> *Subject:* Re: [nvo3] FW: New Version Notification for
> draft-spallagatti-bfd-vxlan-03.txt
>
>
>
> Hi Greg,
>
>
>
> I think Larry has covered the points I was trying to bring up...if there's
> a MAC header present, then the VXLAN GPE next header has to indicate
> "Ethernet" rather than "IPv4" or "IPv6".
>
>
>
> Thanks,
>
> Anoop
>
>
>
> On Mon, May 23, 2016 at 12:47 PM, Greg Mirsky <gregimirsky@gmail.com>
> wrote:
>
> +BFD WG and RTGWG OOAM DT
>
>
>
> Hi Anoop,
>
> thank you for your review and the question. The scope of this draft is
> only for the VXLAN. The Overlay OAM Desing Team is working on the
> Requirements, Gap Analysis and, if there will be required, enhancements
> and/or new OAM protocols for BIER, NSH, VXLAN-GPE, GENEVE, and GUE, as
> defined in its charter. Would appreciate you review and comments of the two
> documents the OOAM-DT already presented in BA meeting:
>
>    - OOAM Requirements
>    - OAM for Overlay Networks: Gap analysis
>
> In the latter you'll find the example to demonstrate applicability of BFD
> Async mode in BIER domain. As we've discussed, other BFD may be applied to
> other overlay networks that I've listed above even though their method of
> indication OAM payload may be different from BIER. Would you agree, or
> suggest to have another example of BFD?
>
>
>
> Regards, Greg
>
>
>
> On Mon, May 23, 2016 at 12:26 PM, Anoop Ghanwani <anoop@alumni.duke.edu>
> wrote:
>
> Authors,
>
>
>
> In section 4.1, you have this:
>
> >>>
>
>    Next Protocol Field in GPE header MUST be set to IPv4 or IPv6.
>
> ...
>
>    The BFD packet MUST be carried inside the inner MAC frame of the
>
>    VxLAN packet.  The inner MAC frame carrying the BFD payload has the
>
>    following format:
>
> >>>
>
>
>
> These two statements seem to contradict each other.  If the GPE header
> indicates IPv4 or IPv6, then how can the BFD packet be encapsulated within
> a MAC frame?
>
>
>
> Can you please clarify?
>
>
>
> Thanks,
>
> Anoop
>
>
>
>
>
> On Mon, May 23, 2016 at 8:15 AM, Bocci, Matthew (Nokia - GB) <
> matthew.bocci@nokia.com> wrote:
>
> Folks
>
> Please could you direct any discussion on this draft to the NVO3 working
> group list.
>
> Regards
>
> Matthew
>
> On 18/04/2016, 07:54, "nvo3 on behalf of Vengada Prasad Govindan
> (venggovi)" <nvo3-bounces@ietf.org on behalf of venggovi@cisco.com> wrote:
>
> >Hello all,
> >  The authors request comments on the draft below.
> >Thanks
> >Prasad
> >
> >-----Original Message-----
> >From: internet-drafts@ietf.org [mailto:internet-drafts@ietf.org]
> >Sent: Saturday, April 16, 2016 11:33 AM
> >To: MALLIK MUDIGONDA (mmudigon) <mmudigon@cisco.com>; Basil Saji
> ><sbasil@juniper.net>; Greg Mirsky <gregory.mirsky@ericsson.com>; Vengada
> >Prasad Govindan (venggovi) <venggovi@cisco.com>; Juniper Networks
> ><santoshpk@juniper.net>; Sudarsan Paragiri <sparagiri@juniper.net>;
> >Santosh Pallagatti <santoshpk@juniper.net>; sajibasil@gmail.com
> ><sbasil@juniper.net>
> >Subject: New Version Notification for draft-spallagatti-bfd-vxlan-03.txt
> >
> >
> >A new version of I-D, draft-spallagatti-bfd-vxlan-03.txt
> >has been successfully submitted by Vengada Prasad Govindan and posted to
> >the IETF repository.
> >
> >Name:          draft-spallagatti-bfd-vxlan
> >Revision:      03
> >Title:         BFD for VXLAN
> >Document date: 2016-04-15
> >Group:         Individual Submission
> >Pages:         9
> >URL:
> >https://www.ietf.org/internet-drafts/draft-spallagatti-bfd-vxlan-03.txt
> >Status:
> >https://datatracker.ietf.org/doc/draft-spallagatti-bfd-vxlan/
> >Htmlized:
> https://tools.ietf.org/html/draft-spallagatti-bfd-vxlan-03
> >Diff:
> >https://www.ietf.org/rfcdiff?url2=draft-spallagatti-bfd-vxlan-03
> >
> >Abstract:
> >   This document describes use of Bidirectional Forwarding Detection
> >   (BFD) protocol for VXLAN .
> >
> >
> >
> >
> >
> >
> >Please note that it may take a couple of minutes from the time of
> >submission until the htmlized version and diff are available at
> >tools.ietf.org.
> >
> >The IETF Secretariat
> >
> >_______________________________________________
> >nvo3 mailing list
> >nvo3@ietf.org
> >https://www.ietf.org/mailman/listinfo/nvo3
>
> _______________________________________________
> nvo3 mailing list
> nvo3@ietf.org
> https://www.ietf.org/mailman/listinfo/nvo3
>
>
>
>
> _______________________________________________
> nvo3 mailing list
> nvo3@ietf.org
> https://www.ietf.org/mailman/listinfo/nvo3
>
>
>
>
>