Re: [spring] [IPv6] Subject: Mandating SRH when using C-SIDs (draft-ietf-spring-srv6-srh-compression)

[Tom Herbert <[e-mail]>]

On Thu, Apr 4, 2024, 3:12 PM Robert Raszuk <[e-mail]> wrote:

> Tom,
>
> >  SR aware routers to update L4 checksum
>
> That is completely unrealistic.
>
> Show me the box which can forward all interfaces at 800 Gb/s and read
> entire each packet and compute upper layer checksum on it.
>

Robert,

It's not necessary to calculate the whole checksum, only the L4 checksum
needs to be updated by adding in the delta checksum. With IPv6 we can also
do a checksum neutral mapping. Basically, this uses the low order 16 bits
in the DA address as the checksum adjustment value. For instance, if we can
use the low order bits in a SID block then that would be simplest to
implement.

Tom


> If anything just do encap and move on.
>
> Thx,
> R.
>
>
> On Thu, Apr 4, 2024 at 7:06 PM Tom Herbert <[e-mail]> wrote:
>
>>
>>
>> On Thu, Apr 4, 2024, 12:30 PM Robert Raszuk <[e-mail]> wrote:
>>
>>> Hi Tom,
>>>
>>> Yes I am with you here.
>>>
>>> However let's observe that this is pretty common best practice to
>>> disable any hardware offload on the box when running tcpdump or wireshark.
>>>
>>> In fact some implementations (F5) do it for you automagically :)
>>>
>>> And as it has been said based on the fact that hardware offload does not
>>> understand any Routing Headers it really does not matter if it is there or
>>> not :)
>>>
>>
>> Robert,
>>
>> tcpdump is independent of hardware offload. If the checksum is incorrect
>> per the packet contents we'll see bad checksums reported if we snoop
>> packets, but like I said, we can't differentiate the bad from the good.
>>
>> Offload becomes an issue for NICs that do protocol specific checksum
>> offload. We lose the capability on RX which is an inconvenience, on TX we'd
>> need to change the implementation to ensure the checksum is not computed by
>> HW.
>>
>> If SR without SRH is needed, then I believe the best answer is for SR
>> aware routers to update L4 checksum when they change DA per NAT
>> requirements. This solves tcpdump as well as offloads.
>>
>> Tom
>>
>>
>>> Cheers,
>>> R.
>>>
>>>
>>> On Thu, Apr 4, 2024 at 6:11 PM Tom Herbert <tom=
>>> [e-mail]> wrote:
>>>
>>>>
>>>>
>>>> On Thu, Apr 4, 2024, 11:48 AM Francois Clad <[e-mail]>
>>>> wrote:
>>>>
>>>>> Hi Tom,
>>>>>
>>>>> Tcpdump can determine that this packet is steered onto an SRv6 path by
>>>>> checking if the DA matches the SRv6 SID block.
>>>>>
>>>>
>>>> Francois,
>>>>
>>>> That would require introducing external state to tcpdump for correct
>>>> operation. This would be a major divergence in both implementation and ops
>>>> compared to how things work today.
>>>>
>>>> Tom
>>>>
>>>>
>>>>
>>>>> Thanks,
>>>>> Francois
>>>>>
>>>>> On 4 Apr 2024 at 16:59:59, Tom Herbert <[e-mail]> wrote:
>>>>>
>>>>>>
>>>>>>
>>>>>> On Thu, Apr 4, 2024, 9:39 AM Francois Clad <[e-mail]>
>>>>>> wrote:
>>>>>>
>>>>>>> Hi Mark,
>>>>>>>
>>>>>>> Tcpdump/wireshark decodes the IPv6 header just fine. I do not see
>>>>>>> any issue here.
>>>>>>>
>>>>>>
>>>>>> Francois,
>>>>>>
>>>>>> The problem is that tcpdump can't tell that a packet is an SR packet
>>>>>> if there's no SRH. For instance, if the checksum is not maintained to be
>>>>>> correct in the wire then tcpdump will show that the packet has a bad L4
>>>>>> checksum, but there's no way to tell if that is an SR packet or if the
>>>>>> checksum is actually bad. This will make debugging checksum failures in the
>>>>>> network much more difficult, and this affects our ability to debug all
>>>>>> traffic not just SR packets.
>>>>>>
>>>>>> Tom
>>>>>>
>>>>>>
>>>>>>> Cheers,
>>>>>>> Francois
>>>>>>>
>>>>>>> On 4 Apr 2024 at 14:09:43, Mark Smith <[e-mail]>
>>>>>>> wrote:
>>>>>>>
>>>>>>>>
>>>>>>>>
>>>>>>>> On Thu, 4 Apr 2024, 22:50 Francois Clad, <[e-mail]>
>>>>>>>> wrote:
>>>>>>>>
>>>>>>>>> Hi Alvaro, all,
>>>>>>>>>
>>>>>>>>> RFC 8754 allows the SR source node to omit the SRH when it
>>>>>>>>> contains redundant information with what is already carried in the base
>>>>>>>>> IPv6 header. Mandating its presence for C-SID does not resolve any problem
>>>>>>>>> because it will not provide any extra information to the nodes along the
>>>>>>>>> packet path.
>>>>>>>>>
>>>>>>>>
>>>>>>>> How are troubleshooting tools like 'tcpdump' going to know how to
>>>>>>>> automatically decode these packets as SRv6 packets if there is no SRH?
>>>>>>>>
>>>>>>>>
>>>>>>>>
>>>>>>>>> Specifically for the case of middleboxes attempting to verify the
>>>>>>>>> upper-layer checksum,
>>>>>>>>>
>>>>>>>>>    - An SRv6-unaware middlebox will not be able to verify the
>>>>>>>>>    upper-layer checksum of SRv6 packets in flight, regardless of whether an
>>>>>>>>>    SRH is present or not.
>>>>>>>>>    - An SRv6 and C-SID aware middlebox will be able to find the
>>>>>>>>>    ultimate DA and verify the upper-layer checksum in flight, regardless of
>>>>>>>>>    whether an SRH is present or not.
>>>>>>>>>
>>>>>>>>>
>>>>>>>>> Furthermore, transit nodes (e.g., middleboxes) should not attempt
>>>>>>>>> to identify SRv6 traffic based on the presence of the SRH, because they
>>>>>>>>> will miss a significant portion of it: all the best-effort or Flex-Algo
>>>>>>>>> traffic steered with a single segment may not include an SRH, even without
>>>>>>>>> C-SID. Instead, RFC 8402, 8754, and 8986 define identification rules based
>>>>>>>>> on the SRv6 SID block.
>>>>>>>>>
>>>>>>>>> Thanks,
>>>>>>>>> Francois
>>>>>>>>>
>>>>>>>>>
>>>>>>>>> On 2 Apr 2024 at 19:44:51, Alvaro Retana <[e-mail]>
>>>>>>>>> wrote:
>>>>>>>>>
>>>>>>>>>> [Moving this conversation up on your mailbox. :-) ]
>>>>>>>>>>
>>>>>>>>>> [Thanks, Robert and Tom for your input!]
>>>>>>>>>>
>>>>>>>>>>
>>>>>>>>>> We want to hear from more of you, including the authors. Even if
>>>>>>>>>> you already expressed your opinion in a different thread, please chime in
>>>>>>>>>> here.
>>>>>>>>>>
>>>>>>>>>> We will collect feedback until the end of this week.
>>>>>>>>>>
>>>>>>>>>> Thanks!
>>>>>>>>>>
>>>>>>>>>> Alvaro.
>>>>>>>>>>
>>>>>>>>>> On March 28, 2024 at 8:06:18 AM, Alvaro Retana (
>>>>>>>>>> [e-mail]) wrote:
>>>>>>>>>>
>>>>>>>>>>
>>>>>>>>>> Focusing on the C-SID draft, some have suggested requiring the
>>>>>>>>>> presence of the SRH whenever C-SIDs are used. Please discuss whether that
>>>>>>>>>> is the desired behavior (or not) -- please be specific when debating the
>>>>>>>>>> benefits or consequences of either behavior.
>>>>>>>>>>
>>>>>>>>>> Please keep the related (but independent) discussion of requiring
>>>>>>>>>> the SRH whenever SRv6 is used separate. This larger topic may impact
>>>>>>>>>> several documents and is better handled in a different thread (with 6man
>>>>>>>>>> and spring included).
>>>>>>>>>>
>>>>>>>>>> Thanks!
>>>>>>>>>>
>>>>>>>>>> Alvaro
>>>>>>>>>> -- for spring-chairs
>>>>>>>>>>
>>>>>>>>>>
>>>>>>>>>> --------------------------------------------------------------------
>>>>>>>>>> IETF IPv6 working group mailing list
>>>>>>>>>> [e-mail]
>>>>>>>>>> Administrative Requests:
>>>>>>>>>> https://www.ietf.org/mailman/listinfo/ipv6
>>>>>>>>>>
>>>>>>>>>> --------------------------------------------------------------------
>>>>>>>>>>
>>>>>>>>>
>>>>>>>>> --------------------------------------------------------------------
>>>>>>>>> IETF IPv6 working group mailing list
>>>>>>>>> [e-mail]
>>>>>>>>> Administrative Requests:
>>>>>>>>> https://www.ietf.org/mailman/listinfo/ipv6
>>>>>>>>>
>>>>>>>>> --------------------------------------------------------------------
>>>>>>>>>
>>>>>>>> --------------------------------------------------------------------
>>>>>>> IETF IPv6 working group mailing list
>>>>>>> [e-mail]
>>>>>>> Administrative Requests: https://www.ietf.org/mailman/listinfo/ipv6
>>>>>>> --------------------------------------------------------------------
>>>>>>>
>>>>>> --------------------------------------------------------------------
>>>> IETF IPv6 working group mailing list
>>>> [e-mail]
>>>> Administrative Requests: https://www.ietf.org/mailman/listinfo/ipv6
>>>> --------------------------------------------------------------------
>>>>
>>>