Re: [nvo3] [MBONED] NVO3 Multicast Framework

[Dino Farinacci <[e-mail]>]

> On May 24, 2016, at 3:37 PM, Anoop Ghanwani <[e-mail]> wrote:
> 
> Hi Dino,
> 
> If switch table sizes for IP multicast forwarding are a consideration, would SSM still be the preferred method?

It depends on the number of sources. But an (S,G) and a (*,G), each represent one entry. If you use Bidir, then only (*,G) entries are supported at the expense of longer paths from any source.

The same ole tradeoff.

But for multicast overlays, where the underlay supports multicast, that state in the core can be reduced to the number ITRs (source-VTEP) sending to the ETR (destination-VTEP) group. So, for example,
1000 sources behind ITRa, that sends to many different groups where the same set of ETRb and ETRc have receivers, then only a single (ITRa,G) entry is necessary in the multicast underlay.

Dino

> 
> Thanks,
> Anoop
> 
> On Tue, May 24, 2016 at 12:37 PM, Dino Farinacci <[e-mail]> wrote:
> Both RFC6831 and draft-ietf-lisp-signal-free describe why SSM is a preferred solution. 
> 
> Dino
> 
> On May 24, 2016, at 12:35 PM, Anoop Ghanwani <[e-mail]> wrote:
> 
>> Thanks Beau & Dino.
>> 
>> We'll add a reference to RFC 6831 and a brief discussion of SSM.
>> 
>> Anoop
>> 
>> On Tue, May 24, 2016 at 11:42 AM, Dino Farinacci <[e-mail]> wrote:
>> If a reference to RFC6831 is provided, then there are many details on how an underlay can support ASM, Bidir, and SSM.
>> 
>> Dino
>> 
>> > On May 24, 2016, at 11:35 AM, Williamson, Beau <[e-mail]> wrote:
>> >
>> > I'd like to see Section 3.4, "IP multicast in the underlay" expanded a bit.
>> >
>> > The section mentions the use of BIDIR for a scalable underlay.  The sad fact is that many vendors still do not fully support BIDIR in their devices (after how many years?) or have limitations on its use that preclude it as a viable option.  I'm no expert in these Underlay sort of DC to DC networks but it seems that SSM would not have that issue since it is basically a subset (and much simpler to implement and configure) of the PIM protocol and would therefore be available in pretty much all vendor devices that support multicast.  The problem is one of Source Discovery of the VTEPs (or, in the case of this draft I think the term is NVE) which would be the sources of the multicast traffic in each TS.
>> >
>> > At the very least, I'd like to see a paragraph discussing the possible use of SSM as an alternative to BIDIR if the VTEP/NVE devices had a way to learn of each other's IP address so that they could join all SSM SPT's to create/maintain an underlay SSM IP Multicast tunnel solution.  This would greatly simplify the configuration and management of the underlay IP Multicast environment.
>> >
>> > I realize that the VTEP/NVE Source Discovery problem is beyond the scope of this Framework document but I'd like to see the above mentioned to possibly encourage more work in this area if it is not already underway.
>> >
>> >
>> > Beau Williamson
>> > CCIE #1346 R/S Emeritus
>> > Principal Member of Technical Staff
>> > Corporate Engineering
>> > metroPCS/T-Mobile
>> > Internal: 314982
>> > Office:   469.330.4982
>> > Mobile:   [phone]
>> >
>> >
>> > -----Original Message-----
>> > From: MBONED [mailto:[e-mail]] On Behalf Of Dino Farinacci
>> > Sent: Tuesday, May 24, 2016 12:21 PM
>> > To: Bocci, Matthew (Nokia - GB)
>> > Cc: MBONED WG; <[e-mail]>
>> > Subject: Re: [MBONED] NVO3 Multicast Framework
>> >
>> > Sorry, I thought I had. NVo3, see my comments below.
>> >
>> > Dino
>> >
>> >> On May 24, 2016, at 6:14 AM, Bocci, Matthew (Nokia - GB) <[e-mail]> wrote:
>> >>
>> >> Hi Dino
>> >>
>> >> Could you copy NVO3 on your comments, please?
>> >>
>> >> Thanks
>> >>
>> >> Matthew
>> >>
>> >> From: EXT Dino Farinacci <[e-mail]>
>> >> Date: Monday, 16 May 2016 at 23:31
>> >> To: Leonard Giuliano <[e-mail]>
>> >> Cc: MBONED WG <[e-mail]>, Matthew Bocci <[e-mail]>, Benson Schliesser <[e-mail]>
>> >> Subject: Re: [MBONED] NVO3 Multicast Framework
>> >>
>> >> I just have one minor comment. Regarding the second paragraph:
>> >>
>> >> <PastedGraphic-2.png>
>> >>
>> >> Using LISP-signal-free does not mean the head-end must do replication. The draft indicates that a mapping system is used to decide where packets go. If the mapping database indicates that packets are encapsulated to multicast RLOCs, or unicast RLOCs, or both in one set, so be it.
>> >>
>> >> And note if there is a single multicast RLOC, then there is no replication happening at the head-end, just one packet encapsulting multicast in multicast.
>> >>
>> >> So what is written above is true, but it may be associated with an incorrect section title.
>> >>
>> >> Dino
>> >>
>> >>> On May 12, 2016, at 2:52 PM, Leonard Giuliano <[e-mail]> wrote:
>> >>>
>> >>> MBONED,
>> >>>
>> >>> The following draft recently went through WG last call in the NVO3 working group:
>> >>>
>> >>> https://datatracker.ietf.org/doc/draft-ietf-nvo3-mcast-framework/
>> >>>
>> >>> This doc covers multicast in data center overlay networks.  As you know, it is part of our charter in MBONED to provide feedback to other relevant working groups.  Please review and send any comments to the NVO3 WG mailing list ([e-mail])- all comments will be greatly appreciated by NVO3.
>> >>>
>> >>> _______________________________________________
>> >>> MBONED mailing list
>> >>> [e-mail]
>> >>> https://www.ietf.org/mailman/listinfo/mboned
>> >>
>> >> <PastedGraphic-2.png>
>> >
>> > _______________________________________________
>> > MBONED mailing list
>> > [e-mail]
>> > https://www.ietf.org/mailman/listinfo/mboned
>> 
>> _______________________________________________
>> nvo3 mailing list
>> [e-mail]
>> https://www.ietf.org/mailman/listinfo/nvo3
>> 
>